Table of Contents
Advertisement
BASICS
Initial Setup
Thermo-Hygro Sensor
Power Up
Weather Station
Insert the Power Cord into a USB Power Adapter (not included), but sure the adapter is securely
plugged into a working outlet. Then insert the Power Jack end into the back of the station.
Remove the Insulation Tab from the station's Battery Compartment.
Thermo-Hygro Sensor
Install 2 fresh "AA" batteries according to polarity and replace battery cover. The blue LED light
will flash when transmitting.
Note:
It may take up to 10 minutes for your sensor data to appear on your
station's screen.
(LTV-TH5i)
Back of Station
(V15-AU)
Power Jack
02
Advertisement
Table of Contents
