Table of Contents
Advertisement
Atomic Time
•
Your Clock will automatically search for the Atomic Time Signal at UTC
7:00, 8:00, 9:00, 10:00, and 11:00.
•
Press the
button to manually start or stop search for the WWVB Atomic
Time Signal.
•
While searching, the Tower Icon
when the WWVB Signal is received by your clock.
•
For information about WWVB Atomic Time visit:
Search for Sensors
If you are seeing "NO" or dashes for any sensor readings, please try the
following steps:
1.
Hold the
PLUS (+)
The Reception Indicator
2.
If after 3 minutes the sensor still isn't connected, bring the sensor inside next
to the display and remove power from the sensor and clock.
3.
Press any button on the station 20 times and leave the parts sit for a few
moments with the power off.
4.
Install a new set of alkaline batteries into the sensor, then power up your
clock again.
5.
If your sensor data is still not appearing after these steps, please contact our
support staff. For additional help visit:
button to search for all sensors.
will begin to animate.
will flash. The Tower Icon will be solid
bit.ly/atomic_time
bit.ly/basic_restart
6
Advertisement
Table of Contents
