Table of Contents
Advertisement
Fault
The spin result is not
satisfactory. The laun-
dry is too wet/too
damp.
Detergent residue on
the damp washing.
Detergent residue on
the dry laundry.
Cause and troubleshooting
Drain pipe or water outlet hose is blocked.
Clean the drain pipe and the water outlet hose.
▶
Drain pipe or water drain hose is caught or jammed.
Ensure that the drain pipe and water drain hose are
▶
not kinked or trapped.
The unbalanced load detection system has interrupted
the spin cycle because the laundry is unevenly distrib-
uted.
Redistribute the laundry in the drum.
▶
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
Start the Spin programme.
▶
Unbalance load detection system is using a reduced
spin speed to eliminate an unbalance.
Redistribute the laundry in the drum.
▶
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
Start the Spin programme.
▶
Detergents may contain water-insoluble substances
that deposit on the laundry.
Start the Rinse programme.
▶
Unsuitable detergent added to the dispenser of the in-
telligent dosing system.
Check whether the detergent used is suitable.
1.
→ "Detergents and care products", Page 32
Drain the dispenser.
2.
→ "Cleaning the detergent drawer", Page 41
Clean the dispenser.
3.
Refill the dispenser.
4.
→ "Pouring liquid detergent and fabric softener into
the dispensers", Page 36
Basic dosage not adjusted.
If intelligent dosing is activated, reduce the basic
▶
dosage. → Page 37
Detergents may contain water-insoluble substances
that deposit on the laundry.
Brush out the laundry after washing and drying.
▶
Troubleshooting en
55
Advertisement
Table of Contents
