Table of Contents
Advertisement
en Troubleshooting
Fault
The spin programme
does not start.
Water is leaking out at
the water inlet hose.
Water is leaking out at
the water outlet hose.
Insufficient cleaning.
The spin result is not
satisfactory. The laun-
dry is too wet/too
damp.
54
Cause and troubleshooting
Start the Spin programme.
▶
Water inlet hose is not correctly/securely connected.
Connect the water supply hose correctly.
1.
→ "Connecting the water inlet hose", Page 15
Tighten the screw connection.
2.
The water outlet hose is damaged.
Replace the damaged water outlet hose.
▶
Water outlet hose is not connected correctly.
Connect the water outlet hose correctly.
▶
→ "Water outlet connection types", Page 16
Basic dosage not adjusted.
If intelligent dosing is activated, adjust the basic
▶
dosage. → Page 37
Detergent or care products have congealed in dis-
pensers of the intelligent dosing system.
Check whether the detergent used is suitable.
1.
→ "Detergents and care products", Page 32
Drain the dispenser.
2.
→ "Cleaning the detergent drawer", Page 41
Clean the dispenser.
3.
Refill the dispenser.
4.
→ "Pouring liquid detergent and fabric softener into
the dispensers", Page 36
Unsuitable detergent added to the dispenser of the in-
telligent dosing system.
Check whether the detergent used is suitable.
1.
→ "Detergents and care products", Page 32
Drain the dispenser.
2.
→ "Cleaning the detergent drawer", Page 41
Clean the dispenser.
3.
Refill the dispenser.
4.
→ "Pouring liquid detergent and fabric softener into
the dispensers", Page 36
A low spin speed is selected.
The next time you run a wash cycle, set a higher
▶
spin speed.
Start the Spin programme.
▶
Reduced Ironing is activated.
Select the programmes that are suitable for the
▶
type of fabric.
Advertisement
Table of Contents
