Error Code - FujiFilm Revoria Press SC180 Error Code List

Error Code

 This manual may not be edited, modified or copied in whole or part without the written consent of the
publisher.
 Parts of this manual is subject to change without prior notice.
If an error code is displayed, any print data remaining in the device and information stored in the device's
memory is not secured.
If an error code is displayed that is not listed in the following table, or if you cannot resolve an error despite
following the instructions described in the table, contact your local representative.
Cause
Error Code
An error occurred during
002-500
the scan job.
003-311 An error occurred.
003-313 Failed to access the RAM.
Failed to access the
003-314
NVRAM.
003-318 An error occurred.
003-319 An error occurred.
003-338 An error occurred.
003-339 An error occurred.
003-340 An error occurred.
003-341 An error occurred.
003-342 An error occurred.
003-343 An error occurred.
003-344 An error occurred.
003-345 An error occurred.
003-346 An error occurred.
Failed to access the SD
003-347
card.
003-348 An error occurred.
Too many documents are
set in the document
003-700
feeder after clearing the
paper jam.
Execute the operation again. Also, check whether or not the account limit for the
Scan service is set.
Switch off the device power, make sure that the touch screen is blank, and then
switch on the device power.
Switch off the device power, make sure that the touch screen is blank, and then
switch on the device power.
Switch off the device power, make sure that the touch screen is blank, and then
switch on the device power.
Switch off the device power, make sure that the touch screen is blank, and then
switch on the device power.
Switch off the device power, make sure that the touch screen is blank, and then
switch on the device power.
Switch off the device power, make sure that the touch screen is blank, and then
switch on the device power.
Switch off the device power, make sure that the touch screen is blank, and then
switch on the device power.
Switch off the device power, make sure that the touch screen is blank, and then
switch on the device power.
Switch off the device power, make sure that the touch screen is blank, and then
switch on the device power.
Switch off the device power, make sure that the touch screen is blank, and then
switch on the device power.
Switch off the device power, make sure that the touch screen is blank, and then
switch on the device power.
Switch off the device power, make sure that the touch screen is blank, and then
switch on the device power.
Switch off the device power, make sure that the touch screen is blank, and then
switch on the device power.
Switch off the device power, make sure that the touch screen is blank, and then
switch on the device power.
Switch off the device power, make sure that the touch screen is blank, and then
switch on the device power.
Switch off the device power, make sure that the touch screen is blank, and then
switch on the device power.
Check the output, and then replace the documents that have not been copied
yet.
2
Remedy