Table of Contents
Advertisement
Tuner
Symptom
A station which was preset cannot be
received by pressing the correspond-
ing numeric key.
Interference.
No antenna is connected.
The broadcast band is not set properly.
The frequency of the desired station is
not tuned.
The preset station belongs
to a fre-
quency that cannot be received.
The
preset memory
was
cleared
be-
cause
the power
cord had been
un-
piugged for a long period of time.
Noise due to ignition noise of an auto-
mobile.
Connect an antenna.
Set the broadcast band properly.
Tune the frequency of the desired sta-
tion.
Preset a station with a receivable fre-
quency.
Preset the station again.
Install the outdoor antenna apart from
the road.
Noise
due to an
influence
from
an
electric appliance.
Noise due to a nearby TV set.
Turn off the power of the appliance.
Install the system more apart from the
TV set.
For the U.S.A.
FCC WARNING
This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference
unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment
if an unauthorized change or modification is made.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may
cause harmful interference to radio communications, !f it is not installed and used in accordance with the instructions. However, there js
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the inter-
Terence by one or more of the following measures:
—-— Reorfent or relocate the receiving antenna.
—-— Increase the separation between the equipment and receiver.
:
-—- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—- Consult the dealer or an experienced radio / TV technician for help.
For the U.S.A.
Note to CATV system installer:
This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper
grounding and, in particular, specifies that cable grounding shall be connected to the ground system of the building, as close to the point
of cable entry as practical.
Notes:
1. This system is microprocessor-controlled, so malfunction may occur due to external noise or interference noise. In such a case,
unplug the power cord, plug it again keeping the POWER
key pressing. (In this case, all the memories are cleared.)
2. Do not use contact cleaners because it could cause a malfunction. Be specially careful against contact cleaners containing oil, for they
may deform the plastic components.
KR-V7050 (En) 33
Advertisement
Table of Contents
