Polaris 550 Indy Sport 2024 Owner's Manual page 113

11. Start and run the engine. Allow the engine to run for at least 15 minutes.
Occasionally "blip" the throttle to rev the engine.
The exhausted may emit more smoke than usual as the fogging oil is burned
12. While the engine is running, verify there are no coolant leaks (on liquid
cooled engines). After engaging the throttle a few times to spin the track,
verify the track is aligned with the slide rails.
13. Turn off the engine. If the track requires, re-align the track at this time.
14. After adjusting the track or allowing the engine to cool down. Add coolant to
reservoir bottle if required.
15. Re-start the engine and allow it to run for another 15 minutes. After 15
Minutes, shutoff the engine and allow the exhaust pipe to cool.
16. Remove and discard the spark plugs. Install new spark plugs into the engine.
Obtain two more new spark plugs and install them into the spark plug holders
or storage bag.
17. Inspect the ski wear bars/carbides. Now is the time to replace the wear bars
if damage if found or carbides are worn.
18. Add Carbon Clean to the fuel tank.
19. Log onto www.ridecommand.com and download the latest TRAILS PIDD
update files. Update the PIDD (if equipped) with the latest TRAILS update
file.
20. Grease the rear suspension grease zerks with Polaris Premium All Season
grease just enough to push out any water that may have accumulated in the
suspension pivot points.
NOTICE
out of the engine.
MAINTENANCE
111