BMW i7 Owner's Manual page 65

▷ The vehicle can be exited during the instal-
lation.
▷ Charging the vehicle is interrupted due to
the installation.
▷ Following the successful installation, charg-
ing the vehicle may not continue automati-
cally.
Prerequisites for the installation
▷ The state of charge of the vehicle battery is
sufficient.
▷ The outside temperature is above
14 ℉/-10 ℃.
▷ The vehicle is parked in a horizontal posi-
tion.
▷ The hazard warning system is turned off.
▷ The selector lever position P is engaged.
▷ Drive-ready state is switched off.
If applicable, follow the notes for further pre-
requisites on the control display.
Your vehicle can establish some prerequisites
automatically. Follow the instructions on the
control display.
If the prerequisites are not met such as a suffi-
cient vehicle battery charge state, the upgrade
will not be offered for installation.
Pay attention to an offer for installation, e.g.,
after charging the battery for a longer period of
time.
Preparing the vehicle
▷ Park the vehicle safely away from the public
road.
▷ Cellular network reception must be ensured
so that a fault message can be sent to the
vehicle manufacturer, for instance if the in-
stallation is terminated.
▷ Close the windows.
▷ Close the trunk.
▷ Remove energy consuming devices such as
a mobile phone.
BMW Remote Software Upgrade
Online Edition for Part no. 01405A88D67 - VI/23
▷ The vehicle key must be located in the vehi-
cle for the consent for installation.
▷ Switch off the exterior lighting.
▷ Remove the devices connected to the diag-
nostic socket.
Installing immediately
The upgrade can be installed immediately
when all prerequisites have been met.
1. Apps menu
2. "All apps"
3. "System settings"
4. "Remote Software Upgrade"
5. "Start upgrade now"
6. Follow the instructions on the control dis-
play.
Installing with timer
When the trip is completed, a timer can be
used to install the upgrade automatically at
a configured time such as during the night.
A later installation may make sense to meet
functional requirements, e.g., a sufficiently
charged vehicle battery.
1. Apps menu
2. "All apps"
3. "System settings"
4. "Remote Software Upgrade"
5. Select the desired settings.
The installation starts automatically when:
▷ All prerequisites for the installation have
been established correctly.
▷ All prerequisites continue to be met at the
time of installation.
The timer is turned off when the drive-ready
state is turned on.
Installing via the My BMW App
If all requirements are met, you can also start
the upgrade installation via the My BMW App.
CONTROLS
65