BMW i7 Owner's Manual page 165

Sensitivity of the Automatic High
Beam Assistant
General information
The sensitivity of the Automatic High Beam
Assistant can be adjusted.
Safety information
Warning
If adjustments have been made or the sen-
sitivity has been modified, oncoming traffic
may be momentarily blinded. There is a risk
of accident. If adjustments have been made
and the sensitivity has been modified, make
sure that oncoming traffic is not momentarily
blinded. Switch off the high beams manually
if required.
Functional requirements
▷ Setting at standstill only.
▷ Drive-ready state is switched on.
▷ Light is turned off.
Increasing sensitivity
Push the turn signal lever to the front for ap-
proximately 10 seconds.
A Check Control message is displayed. The
system responds more sensitively.
Resetting the sensitivity
Push the turn signal lever to the front again
for approx. 10 seconds or switch off the drive-
ready state.
The sensitivity of the Automatic High Beam
Assistant is reset to the factory settings.
System limits
The Automatic High Beam Assistant cannot
replace the driver's personal judgment of when
Online Edition for Part no. 01405A88D67 - VI/23
Light and view
to use the high beams. When appropriate, dim
the high beams manually.
The system may not be fully operational in
the following situations, and driver intervention
may be necessary:
▷ In very unfavorable weather conditions
such as fog or heavy precipitation.
▷ When detecting poorly-lit road users such
as pedestrians, cyclists, horseback riders
and wagons; when driving close to train or
ship traffic; or at animal crossings.
▷ In tight curves, on hilltops or in depressions,
in crossing traffic or half-obscured oncom-
ing traffic on highways.
▷ In poorly-lit towns and cities or in the pres-
ence of highly reflective signs.
▷ When the windshield in front of the interior
mirror is fogged up, dirty or covered with
stickers, etc.
Exterior lighting
Overview
Buttons in the vehicle
CONTROLS
165