Storage; Long Term Storage (Over 30 Days) - Echo PB-265LN Operator's Manual

Power blower

Hide thumbs Also See for PB-265LN:

Table of Contents

PB-265LN

STORAGE

During operation the muffler or catalytic muffler and

surrounding cover become hot. Always keep exhaust area clear

of flammable debris during transportation or when storing,

otherwise serious property damage or personal injury may

result.

Do not store in enclosure where fuel fumes may accumulate or

reach an open flame or spark.

Do not store your unit for a prolonged period of time (30 days or longer)

without performing protective storage maintenance which includes the

following:

Store unit in a dry, dust free place, out of the reach of children.

Place the stop switch or lever in the "OFF" position.

Remove accumulation of grease, oil, dirt and debris from exterior of

unit.

Perform all periodic lubrication and services that are required.

Tighten all the screws and nuts.

Drain fuel tank completely. Press purge bulb 6 -7 times to remove

remaining fuel from carburetor then drain the tank again. Close choke,

start and run the engine until it stops due to lack of fuel.

Allow engine to cool. Remove the spark plug lead from the spark plug.

Remove the spark plug. Pour 7 cc (0.25 oz.) of fresh, clean, two-stroke

engine oil into the cylinder through the spark plug hole.

Pull the recoil starter handle 2-3 times to distribute the oil inside the

engine.

Observe the piston location through the spark plug hole. Pull the recoil

handle slowly until the piston reaches the top of its travel and leave it

there.

10. Install the spark plug. Connect the spark plug lead to the spark plug.

11. Remove blower pipe assembly from unit.

X7531181900

STORAGE

Table of Contents