Table of Contents
Advertisement
Figure 18 XMG-108HP
3.2.1 Power Connection
Note: Make sure you are using the correct power source as shown on the panel.
Connect the supplied power adapter to the power receptacle on the rear panel. Then use the included
power cord to connect the power adapter to an appropriate power source.
3.3 LEDs
The LED Indicators give real-time information about the status of the Switch. After you connect the
power to the Switch, view the LEDs to ensure proper functioning of the Switch and as an aid in
troubleshooting. The following table provides descriptions of the LEDs.
The following table describes the LEDs.
Table 8 LED Descriptions
LED
PWR
PoE MAX
LED
100M/1G/2.5G Base-T Ports
Link / ACT
1 – 5
(XMG-105HP)
1 – 8
(XMG-108 /
XMG-108HP)
Chapter 3 Hardware Panels
COLOR
STATUS
DESCRIPTION
Green
On
The Switch is receiving power from the power module in the power slot.
Blinking
The Switch is rebooting.
Off
The Switch is not receiving power from the power module in the power slot
or the Switch is malfunctioning.
Yellow
On
The Switch's remaining power budget is equal to / less than 10 watt.
Off
The Switch's remaining power budget is above 10 watt.
COLOR
STATUS
DESCRIPTION
Green
On
The link to a 2.5G Ethernet network is up.
Blinking
The Switch is transmitting/receiving to/from a 2.5G Ethernet network.
Fast
The Switch detects loop activity on the 2.5G Ethernet network.
Blinking
Yellow
On
The link to a 100/1000 Mbps Ethernet network is up.
Blinking
The Switch is transmitting/receiving to/from a 100/1000 Mbps Ethernet
network.
Fast
The Switch detects loop activity on the 100/1000 Mbps Ethernet network.
Blinking
Off
The link to an Ethernet network is down, or the uplink port is shut down.
XMG-100 Series User's Guide
20
Advertisement
Table of Contents
