BMW 2 GRAN COUPE Series Manual page 147

The system may not be operational.
The Antilock Braking System is not
available.
The ability to steer may be restricted during full
braking.
Have the vehicle checked immediately by an
authorized service center or another qualified
service center or repair shop.
Additional information:
Antilock Braking System, refer to page 186.
Dynamic Stability Control
Warning light flashes: Dynamic Stabil-
ity Control is regulating the drive and
brake power. The vehicle is stabilized.
Reduce the vehicle speed and adjust your driv-
ing style to the road conditions.
Warning light illuminates: Dynamic Stability
Control has failed or is being initialized. Driving
stability is restricted or has failed.
If the warning light illuminates continuously,
have the vehicle checked immediately by an
authorized service center or another qualified
service center or repair shop.
Additional information:
Dynamic Stability Control, refer to page 187.
The Dynamic Stability Control
deactivated or the Dynamic Traction
Control activated
The Dynamic Stability Control is deacti-
vated or the Dynamic Traction Control
is activated.
Additional information:
▷ Dynamic Stability Control, refer to
page 187.
▷ Dynamic Traction Control, refer to
page 188.
Online Edition for Part no. 01405A89334 - VI/23
Displays
Flat tire monitor
Warning light illuminates: Flat tire or
tire pressure loss has been detected.
Reduce your speed and stop cau-
tiously. Avoid sudden braking and steering
maneuvers.
Additional information:
Flat tire monitor, refer to page 293.
Tire pressure monitor
Warning light illuminates: Flat tire or
tire pressure loss has been detected.
Follow the information in the Check
Control message.
Warning light flashes then illuminates continu-
ously: Flat tires or tire pressure losses cannot
be detected.
▷ Fault caused by systems or devices with
the same radio frequency: after leaving the
area of the interference, the system auto-
matically becomes active again.
▷ In the case of tires with special appro-
val: the tire pressure monitor was unable
to complete the reset. Reset the system
again.
▷ Wheel without wheel electronics installed:
Have it checked by an authorized service
center or another qualified service center or
repair shop as needed.
▷ Malfunction: have the vehicle checked by
an authorized service center or another
qualified service center or repair shop.
Additional information:
Tire pressure monitor, refer to page 286.
Steering system
Steering system may not be opera-
tional.
CONTROLS
147
OwnersManuals2.com