Advertisement
Step 3
C16
NOTE
The remainder of the building assembly
requires many hours and more than one
person. Do not continue beyond this
point if you do not have enough time to
complete the assembly today. A partially
assembled building can be severely
damaged by light winds.
Each screw and bolt in the wall
requires a washer.
CORRECT
1
Position front corner panels at the
corners of the oor frame as shown.
The widest part of each corner panel
must be placed at the front of the build-
ing. Fasten the corner panels to the
oor frame with two screws.
2
Position rear corner panels at rear
of building as shown. The widest part
of each corner panel must be placed
along side of the building. Fasten
corner panels to the oor frame using
four screws.
NOTE
The wall panels come in two
widths. Each wall panel has a
crimped rib on one side. The
crimped rib should go under the
rib of the panel that follows it.
3
Attach wall panels to the sides,
as shown.
NOTE
Be careful to install the correct
panel in each position as shown.
4
Double-check the part numbers of
the wall panels, before proceeding.
Corners/Wall Panels
INCORRECT
STEP
SUPPORT THE CORNER PANEL
WITH A STEP LADDER UNTIL A
WALL PANEL IS ATTACHED.
Parts Needed For
9392
WideSide
STEP
2
SIDE
9388
1
9364
9388
Panels rest on
frame as shown
16
9388 Front Corner Panel (2)
9392 Rear Corner Panel (2)
9364 Wall Panel (2)
Narrow
Side
REAR
TOP VIEW
FRONT
Washer
9392
9388
The oor frame must be square
and level or holes will not align.
9392
SIDE
9388
Crimped Rib
Underneath
9392
9364
STEP
3
Advertisement
