Table of Contents
Advertisement
Quick Links
RS-1604TW1/RS-1704TW2/RS-1804FM
RS1905FM
2-Way Paging Remote Engine Starting & Keyless
Entry System with 1-Way Sidekick Remote Control
-PRIMARY: These are features that must be connected in order for the system to operate properly i.e. Remote
Start connections, Flashing lights, Brake Reset. For programming, the hood pin and program button are required.
-OPTIONAL: These are features are to be connected only if desired or agreed upon by the customer and the
installing dealer i.e. Door Locks, Trunk Pop, Dome Light Illumination, Horn-Honk, Anti-Grind, etc. These features
may also require additional parts and/or labor fees. Consult with your installer beforehand to be sure of what is
going to be installed with your particular system.
TECHNICAL SUPPORT: (800) 998-6880
Monday - Friday 8:00am - 4:30pm Pacific Std. Time
Web Site: www.crimestopper.com
E-mail: email@crimestopper.com
CRIMESTOPPER SECURITY PRODUCTS, INC.
1770 S. TAPO STREET, SIMI VALLEY, CA. 93063
REV C – 09.30.2005
OPERATING INSTRUCTIONS
This device complies with FCC Rules part 15. Operation is
subject to the following two conditions: 1) This device may not
cause interference, and (2) this device must accept any
interference that may be received, including interference that
may cause undesired operation.
responsible for any radio or TV interference caused by
unauthorized modification to this equipment. Such modification
could void the user's authority to operate the equipment.
The manufacturer is not
Advertisement
Table of Contents
Related Manuals for CrimeStopper CoolStart RS-1604TW1
Summary of Contents for CrimeStopper CoolStart RS-1604TW1
- Page 1 TECHNICAL SUPPORT: (800) 998-6880 Monday - Friday 8:00am - 4:30pm Pacific Std. Time Web Site: www.crimestopper.com E-mail: email@crimestopper.com CRIMESTOPPER SECURITY PRODUCTS, INC. 1770 S. TAPO STREET, SIMI VALLEY, CA. 93063 REV C – 09.30.2005 OPERATING INSTRUCTIONS This device complies with FCC Rules part 15. Operation is...
-
Page 2: Table Of Contents
OPERATION CAUTIONS & WARNINGS CRIMESTOPPER SECURITY PRODUCTS, INC. and its VENDORS shall not be liable for any accident resulting from the use of this equipment. This system is designed to be professionally installed into a car or vehicle in which all items, such as parking brake and all associated components, door switches, transmission shift linkage, throttle linkage, and all engine safety features, are in perfect working condition. -
Page 3: 2-Way Paging Led Remote Tw1
#2 (Unlock) Press & Release AUX #1 #3 (Trunk) REMOTE START #4 (Start) ENGINE RUNNING TURN OFF ENGINE #4 (Start) PANIC #1 (Lock) RS-1604TW1 PAGING LED's LOCK TRUNK ACTION BEEPS Press & Release 1X then 1X again 1X then 2X again Press &... -
Page 4: 2-Way Paging Lcd Remote Tw2
2-WAY PAGING LCD REMOTE OPERATION: BUTTON 1 (LOCK Symbol): Press and release to Lock doors. Press and Hold for more than 3 seconds to activate “Panic” feature. BUTTON 2 (Unlock Symbol): Press and release to Unlock doors. BUTTON 3 (Trunk Symbol): Hold two seconds Press and to activate trunk pop (Optional... -
Page 5: 2-Way Paging Lcd Remote Fm
2-WAY PAGING LCD REMOTE OPERATION: BUTTON 1 (Lock Symbol): Press and release to Lock system. Press and Hold for more than 3 seconds to activate “Panic” feature. BUTTON 2 (Unlock Symbol): Press and release to Unlock system. BUTTON 3 (Trunk Symbol): Press and Release to activate trunk pop (Optional Feature). -
Page 6: Using The Remote 1-Way Remote
OPERATION: BUTTON 1 (Lock Symbol): Press and release to Lock doors. Press and Hold for more than 3 seconds to activate “Panic” feature. BUTTON 2 (Unlock Symbol): Press and release to Unlock doors. BUTTON 3 (Trunk Symbol): Press and Hold for two seconds to activate trunk pop (Optional Feature) . - Page 7 USING THE 1-WAY OPERATION: BUTTON 1 (Lock Symbol): Press and release to Lock doors. Press and Hold for more than 3 seconds to activate “Panic” feature. BUTTON 2 (Unlock Symbol): Press and release to Unlock doors. Press 2 times for Driver Door Priority Unlock. BUTTON 3 (Trunk Symbol): Press and Hold for ½...
-
Page 8: Remote Engine Starting
REMOTE ENGINE STARTING REMOTE ENGINE STARTING - SUCCESSFUL START: 1) Press the remote start button for at least 1/2 second (Default) or twice if set for double press. 2) Parking lights flash once; return solid, and the Ignition/Acc circuits turn on. 3) After a few seconds the Starter Motor engages, Parking lights and Acc circuits will turn off while cranking. - Page 9 REMOTE ENGINE STARTING Cont. ENTERING YOUR REMOTE STARTED VEHICLE: 1) With engine running, Remote Unlock system (If equipped) or open door with key. 2) Enter vehicle and be careful not to step on brake pedal! (Remote Start Reset). 3) Turn Ignition to ON/RUN position, then press brake pedal to reset the Remote Starter & Shift out of park. 4) Remote starter will reset instantly when the brake is pressed.
- Page 10 IDLE DOWN MODE - EXITING THE VEHICLE: 1) With vehicle engine running with key, **press the Remote Start button for at least a 1/2 second or twice if set for double press. 2) Parking Lights will turn ON. 3) Doors will unlock, or if brake pedal is being depressed, doors will unlock when it is released. 4) Turn OFF Ignition and remove key.
-
Page 11: Remote Engine Starting
INFINITY RUN MODE – EXITING THE VEHICLE: 1) With vehicle engine running with the key, **press the Remote Start button for at least 1/2 second, pause a few seconds, then press and release the remote start button a second time. 2) Parking Lights will start flashing, and doors will unlock. -
Page 12: Turbo Timer Mode
TURBO TIMER MODE (OPTIONAL) The optional Turbo Timer mode allows the CoolStart system to keep a Turbo or Turbo Diesel vehicle running for 1 to 5 minutes [selectively] after you remove the key, exit t he vehicle, and lock the doors remotely. This is handy for turbo cool-down without the need for expensive turbo timers. -
Page 13: Convenience And Safety Features
CONVENIENCE AND SAFETY FEATURES KEYLESS ENTRY (POWER DOOR LOCK CONTROL, Optional) This system enables you to remotely lock and unlock the vehicle’s doors (if equipped with power locks) via remote control for safety and convenience. Note: This feature may require extra labor and/or parts to install. Press the Lock or Unlock transmitter button as you leave or come near the vehicle. - Page 14 CONVENIENCE AND SAFETY FEATURES VALET MODE / STARTER DISABLE OVERRIDE Before servicing your vehicle or handing the keys over to a Valet we recommend putting the unit into valet mode. The remote start function WILL NOT operate when in Valet mode. To enter Valet mode, turn the key to the ON position, press and hold Program/Valet switch for 5-6 seconds.
-
Page 15: Transmitter Programming
Note: All transmitter codes must be learned at time of programming!! The unit will learns up to 4 different transmitter codes. 1. Open Hood (If no hood pin installed with your system, then you must ground the Gray Hood pin wire). 2. -
Page 16: Vehicle Operation
A single remote can control two different vehicles CoolStart systems installed. However, both systems must be the same type. RS-1604TW1/1704TW2 is not compatible with RS- 1804FM/ 1905FM. Programming: You must first Programming your remote for vehicle operation: Vehicle Programming and Operation instruction):... -
Page 17: Troubleshooting "Before You Call
L.E.D Two-way Remote In step #4 of transmitter programming (see Page 15), press and hold the side button on the LED remote for 5 seconds. The unit will beep 2 times and a yellow LED will flash (now you are in 2 button at the same time on the LED remote, your vehicle should be programmed for the 2 Operation: Press the car vehicle #2 side button on your remote for 5 seconds to enter 2... - Page 18 NO RESPONSE FROM REMOTE TRANSMITTERS: (4 Parts) 1. Check for proper power/ground wiring connections at module. 2. Check Antenna Module connection. The antenna module included with this system must be plugged in. 3. Transmitters may need to be programmed to the unit. See transmitter programming steps on Page 1 5. 4.
-
Page 19: Low Battery Warning And Replacing The Aaa Battery On Lcd Remote
LOW BATTERY WARNING - LCD REMOTE (RS-1604TW1/RS-1704TW2) RS-1604TW1 (LED system): When the battery is low the orange and green LED flash 6 times with any button pressed. RS-1704TW2/RS-1804FM/1905FM (LCD SYSTEM): When the battery is low, a low battery icon turns on. We recommend replacing the battery for proper operation. -
Page 20: Setting The Clock
3. The hour display should begin flashing. Use the lock and unlock button to change the hour up or down to the correct AM or PM hour. 4. Once the correct time is displayed, wait 6 seconds, the remote will beep twice and the time of day is set. www.crimestopper.com email@crimestopper.com © 2005 Crimestopper Security Products ONLINE TECHNICAL SUPPORT http://www.crimestopper.com...