Uniden EXAI 3248 Series Owner's Manual page 14

EXAI3248.Qx 12/12/2 8:11 PM Page 12
[ 12 ] G E T T I N G S T A R T E D
5) Plug the telephone line cord into the telephone outlet.
6) Raise the antenna to a vertical position.
7) Align the mounting slots on the base with the mounting posts on the wall. Then
push in and down until the phone is firmly seated.
Direct wall mounting
If you don't have a standard wall plate, you can mount your phone directly to the
wall. Before doing this, consider the following:
• Avoid electrical cables, pipes, or other items behind the mounting location that
could cause a hazard when inserting screws into the wall.
• Try to mount your phone within 5 feet of a working phone jack to avoid excessive
cord lengths.
• Make sure the wall material is capable of supporting the weight of the base
and handset.
• Use #10 screws (minimum length of 1-3/8 inches) with anchoring devices suitable
for the wall material where the base unit will be placed.
1) Insert two mounting screws into the wall, (with their appropriate
anchoring device), 3-15/16 inches apart. Allow about 1/8 of an
inch between the wall and screw heads for mounting the phone.
2) Refer to steps 1 through 7 on page 13 to mount the telephone.
www.uniden.com