Uniden EXAI 3248 Series Owner's Manual page 10

EXAI3248.Qx 12/12/2 8:11 PM Page 8
• Use only the Uniden
battery (BT-905)
supplied with your
phone. Replacement
batteries are also
available through the
Uniden Parts
Department (see
page 8).
• Recharge your phone
on a regular basis by
returning the handset
to the base after each
phone call.
[ 8 ] G E T T I N G S T A R T E D
B. Install the rechargeable battery pack into
the handset
Charge the battery pack for at least 15-20 hours
before plugging in the telephone line and start using
your phone.
1) Press in on the battery cover release and slide the cover
down until it comes off.
2) Connect the battery pack connector, observing correct
polarity (black and red wires), to the jack inside the
battery compartment.
Do not exert any force on this connection. It could cause
damage to the battery or handset. Once you are certain
that you have made a good connection, then insert the
battery pack into the battery compartment. Do not pinch
the wires.
3) Securely close the battery compartment cover by sliding it
up until it snaps into place.
4) Place the handset on the base.
www.uniden.com