Vacuum Seal Drawer Models; Accessory Door Panels (Purchased Separately) - Fisher & Paykel VB60SMB1-SET Installation Manual

Vacuum seal drawer

Hide thumbs

Table Of Contents

Table of Contents

SAFETY AND WARNINGS

READ AND SAVE THIS GUIDE

To reduce the risk of fire, injury to persons or damage when using the appliance, follow the

important safety guides listed below. Read all the instructions before using the appliance.

Installation

Please make this information available to the person installing the product.

The appliance must be installed by a qualified installer, or Fisher & Paykel trained and

supported service technician to avoid faulty electrical connection.

Ensure the installation complies with all clearance requirements and applicable standards

and regulations.

When installed in combination with a companion product, the companion product can be

placed directly onto the appliance. A built-in shelf at the base of the cabinetry must be

able to support the weight of both products.

Ensure the cabinetry is square and level and with correct dimensions.

If installing the appliance directly underneath an oven, ensure you do not damage the

oven's lower trim. Fisher & Paykel does not accept any responsibility for any damage

resulting from incorrect installation.

Before installing the appliance, inspect for any signs of damage. Do not install or use

damaged appliances.

Be careful when stacking the appliances on top of each other to avoid damage to the

appliances.

Electrical

All connections for electrical power and earthing must be done by a qualified electrician

and must comply with local codes and ordinances.

Before installation, ensure that the voltage and frequency listed on the data plate

corresponds with the household electrical supply.

When combining with another appliance, ensure each appliance has its own power outlet.

Avoid sharing the power point to prevent accidental switching off of the appliance.

Ensure your appliance is properly grounded (earthed).

Connect the drawer to a properly rated, protected and sized power supply circuit to avoid

electrical overload.

Do not use an extension cord or a portable electrical outlet device (e.g. multi-outlet outlet

box) to connect the drawer to the power supply. Ensure the power supply cord is located

so that it will not be stepped on, tripped over or otherwise subject to damage or stress.

Ensure there is a switched outlet in an easily accessible area within 900mm of the centre

rear of the product.

Servicing

Do not repair or replace any part of the appliance unless specifically recommended in the

user guide. All other servicing should be done be a Fisher & Paykel trained and supported

service technician or qualified person.

Always disconnect the power supply before doing any installation, maintenance or repair

work.

If the power supply cord is damaged, it must be replaced by a qualified electrician or

Fisher & Paykel trained and supported service technician.