Install Front Panel (Sold Separately); Adjusting The Height - Fisher & Paykel VB60SMB1-SET Installation Manual

INSTALL FRONT PANEL (SOLD SEPARATELY)

1
2
3
4
Ensure the lower adjustment clip is
engaged on the outside of the drawer,
between the screw and the drawer.
Align the tabs on the panel to the chassis
and slot into place.
If required, adjust panel vertically as
needed.
Tighten the screw to secure.

ADJUSTING THE HEIGHT

The front panel of the drawer can be adjusted vertically to align with the surrounding cabinetry.
1
2
3
Open the drawer fully, and slightly
loosen the two screws.
Adjust to the required height and
then re-tighten the screws. The
height is adjustable within 5mm.
Close the drawer and check
the alignment. Adjust again if
necessary.
13