Gall- Channel .Is.cccciscesiesteacictgevesdicsatessatabazenariness; Recalling The Call Channel; Changing Call Channel! Contents (Simplex) - Kenwood TM-261A Instruction Manual

CALL CHANNEL
'The Call channel can be used to store any frequency and
related data that you want to recail frequently. The Call
channel can be programmed with a simplex or split
frequency as well as related data that can be stored in the
memory channels. No matter what mode the transceiver is
in, the Call channel! always can be selected quickly. You
may want to dedicate the Call channel as an emergency
channel within your group. In this case, the Call/VFO scan
{page 35} will be useful.
The default frequency stored in the Call channel is shown
below.
U.S.A./Canada
400 MHz
China or
450 MHz
430 MHz General 144 MHz
The contents of the Call channel cannot be deleted;
however, you can overwrite old data with new data as
described in the next section.
m@ Recalling the Call Channel
Simply press microphone [CALL] to retrieve the
contents of the Call channel.
* "C" appears on the Display.
(hLibsrarara®
( o¢ Cee wee ies
MHz i TONE. REV
« If microphone [CALL] is pressed again, "C" clears and the
previous mode is restored.
¢ The Tuning control and microphone [UP][DWN] do not
function while the Call channel is selected.
m@ Changing Call Channel! Contents (Simplex)
1 Select the desired frequency and associated data
(Tone, CTCSS, DTSS, etc.) using VFO mode or
Memory Recall {page 26}.
2 Press [F], microphone [CALL].
* The selected frequency and associated data are
stored in the Cali channel. A transmit frequency from
a split memory channel is not stored.
* The previous mode is restored.