Simplex Memory Channels; Split Memory Channels 00 - Kenwood TM-261A Instruction Manual

@ Simplex Memory Channels
1
Select the desired frequency and associated data
(Tone, CTCSS, DTSS, etc.) using VFO mode,
Memory Recall {page 26}, or the Call channel
{page 27}.
Press [F] to enter Function Select mode.
« "FP" and a memory channel number appear.
SHIFT
Turn the Tuning control, or press microphone
[UP])[DWN], to select the desired memory channel.
Press [MR].
* The selected frequency and associated data are
stored in the memory channel. A transmit frequency
from a split memory channel or split Call channel is not
stored.
* Ifthe memory channel selected in the previous step
already contained data, the new data overwrites the
previous data.
¢ The previous mode is restored.
Note: After completing each of Steps 2 and 3, you must execute the
next step within approximately 10 seconds or the previous made is
restored.
@ Split Memory Channels
1
Select the desired receive frequency, and associated
data (Tone, CTCSS, DTSS, etc.) using VFO mode,
Memory Recall {page 26} or the Call channel
{page 27}.
Press [F] to enter Function Select mode.
¢ "F' and amemory channel number appear.
Turn the Tuning control, or press microphone
[UP]/[DWN], to select the desired memory channel.
Press [MR] (1 s).
° "—+" appears.
3
MHz REV
¢ The channel number is visible if using Memory Recall
mode and the Cail channel "C" is visible if using Call
channel mode in Step 1.
Turn the Tuning control, or press microphone
[UP]/[DWN], to select the desired transmit
frequency.
25