Menu Description; Eee Seeeseseeeseeeeeenesentees; Menu Access - Kenwood TM-261A Instruction Manual

MENU SET-UP
MENU DESCRIPTION
Many functions on this transceiver are selected or
configured via software-controlled menus instead of
physical controls on the transceiver. The menus are
identified as Menu A and Menu B. Menu A is used to
access functions that are frequently changed while Menu B
is used for less frequently changed functions.
MENU ACCESS
1 To access Menu A, press [F] (1s).
2 Select the desired menu function by turning the Tuning
control or by pressing microphone [UP})[DWN].
3 The method for selecting the desired menu selection
differs depending on which menu function you selected
in Step 2.
¢ To toggle between two selections or to select from three
selections, press [VFO].
* To select from more than three selections, press [VFO],
then tum the Tuning control or press microphone
[UP/[DWN].
* To select for the menu functions listed below, refer to the
corresponding reference pages:
DTSS Code (Menu A):
"STORING DTSS CODES' on page 37
Memory Channel Lockout (Menu A):
"Locking Out Memory Channels" on page 33
Program Scan (Menu B):
"PROGRAM SCAN" on page 34
DTMF Number Storing (Menu B):
"STORING DTMF NUMBERS FOR THE AUTOMATIC
DIALER?" on page 40
DTMF Number Confirmation (Menu B):
"CONFIRMING STORED DTMF NUMBERS' on page 41
4 Press [F] or microphone [PTT] to exit Menu A or
Menu B.
Note:
¢ if neither key strokes are made nor controls are turned within
approximately 10 seconds after Menu A or Menu B is accessed, the
frequency display is restored.
@ When either Menu A or Menu 8 is accessed after the Reverse
function is activated, Reverse is canceled.
17