Checking The Reversing Valve - Friedrich VERT-I-PAK VHA09K25RTQ Service Manual

Checking The Reversing Valve

NOTE: You must have normal operating pressures before the reversing valve can shift.
Check the operation of the valve by starting the system and switching the operation from "Cooling" to "Heating" and then back
to "Cooling". Rapidly cycle. Do not hammer on valve.
Occasionally, the reversing valve may stick in the heating or cooling position or in the mid-position.
When sluggish or stuck in the mid-position, part of the discharge gas from the compressor is directed back to the suction side,
resulting in excessively high suction pressure.
Should the valve fail to shift from cooling to heating, block the air flow through the outdoor coil and allow the discharge pressure
to build in the system. Then switch the system from heating to cooling.
If the valve is stuck in the heating position, block the air flow through the indoor coil and allow discharge pressure to build in the
system. Then switch the system from heating to cooling.
Should the valve fail to shift in either position after increasing the discharge pressure, replace the valve.
Dented or damaged valve body or capillary tubes can prevent the main slide in the valve body from shifting.
If you determine this is the problem, replace the reversing valve.
After all of the previous inspections and checks have been made and determined correct, then perform the "Touch Test" on the
reversing valve.
Reversing Valve in Heating Mode
36
COMPONENT TESTING
WARNING
HIGH PRESSURE HAZARD
Sealed Refrigeration System contains refrigerant
and oil under high pressure.
Proper safety procedures must be followed,
and proper protective clothing must be worn
when working with refrigerants.
Failure to follow these procedures could
result in serious injury or death.
Figure 604 (Checking The Reversing Valve)