Using Surround; Dolby Pro Logic Surround And Dolby 3Ch Logic; Cece Ce Cccceececencceececescescecueueans - Pioneer VSX-D901S Operating Instructions Manual

USING SURROUND
SURROUND MASTER
MODE VOLUME
SPEAKERS BALANCE JOG JOG MODE
Level
adjustment
button (+) CENTER MODE
Level/Balance
select switch
TEST TONE
Balance
adjustment
buttons (L, R)
@ PIONEER
AUDIO peo paoumammaelE
Remove coerrec. Unt
Level
adjustment
button (—)
DOLBY PRO LOGIC SURROUND AND DOLBY 3CH LOGIC
Use with video or audio software bearing the [){][bousy surrouno |
mark,
Use DOLBY PRO LOGIC SURROUND when rear speakers are
connected, and DOLBY 3CH LOGIC when rear speakers are not
connected.
1. Turn the DOLBY PRO LOGIC or DOLBY 3CH LOGIC button ON.
2. Select the center mode with the remote control CENTER MODE
button.
© Refer to page 6.
LEVEL ADJUSTMENT
For correct SURROUND reproduction, be sure to perform this
adjustment.
1. Use SURROUND MODE buttons to select DOLBY PRO LOGIC
SURROUND or DOLBY 3 CH LOGIC.
. Use SPEAKERS button to turn on front speakers.
. Adjust MASTER VOLUME to a suitable listening level.
. Press BALANCE L and R buttons together.
. Set the remote contro! Level/Balance select switch to the CENT
position, and adjust using the +, - buttons until the center level
is at its initial value (-16 dB) in the display.
a pwh
6. Set the remote control Level/Balance select switch to the REAR
Position, and adjust using the +, - buttons until the center level
is at its initial value (-16 dB) in the display.
32
<ARB1371>
7. Select the desired CENTER MODE (NORMAL, WIDE, PHANTOM)
with the CENTER MODE button. (See page 6)
* With DOLBY 3CH LOGIC, you can select NORMAL or WIDE; but
you cannot select PHANTOM.
eee BURMOUNO MOE --~
Deer omen]
eno -Loarc
* CENTER MocE +
NORMAL
8. Press the remote control TEST TONE button to switch the test tone ON.
9. Adjust so that the volume level is the same from each of the
speakers.
¢ Adjust front speaker balance with the receiver balance buttons.
* To adjust center speaker level, set the remote control
Level/Balance select switch to the CENT position, and adjust with
the +, — buttons.
© For the rear speakers, set the remote control Level/Balance select
switch to the REAR (REAR BAL) position, and adjust the balance
with the L, R buttons, and the level with the +, ~ buttons. (Only
when DOLBY PRO LOGIC SURROUND is operating.)
10. Press the remote control TEST TONE button to switch the test tone
OFF.
11.Use INPUT SELECTOR button to select your desired source.
12. Adjust the desired sound level by the MASTER VOLUME.
NOTE:
* The TEST TONE turns off if you operate the INPUT SELECTOR.
© Remote control buttons will not operate if you press two or more at
the same time. Press the L, R, +, and — buttons one ata time, and
confirm operation by looking at the display or listening to the sound.
* Tone controls do not operate when using DOLBY PRO LOGIC
SURROUND and DOLBY 3CH LOGIC.
| SETTING THE DELAY TIME |
When using DOLBY PRO LOGIC SURROUND, you can set the delay
time between 15 ms and 30 ms. The standard setting is 20 ms, but
you can select any setting of your choice.
1. Use the JOG MODE button to light the DELAY indicator.
° and ms light in the display section.
aM
Jan Yan ms
2. Set the delay time with the JOG dial.