Sennheiser HME 26-600 Service Manual page 13

5.1.4 Disassembling the operating control (for cable -B-7)
1. Remove the 4 Torx screws (060).
2. Remove the cover (010)
3. Take out the knob (030) and the optical waveguide (050), if needed.
4. Take out the inserts (090, 100, 110).
5. Take out the PCB mainboard (040)
6. Desolder the cable (070, 080) from the PCB mainboard (040), if needed.
5.1.5 Disassembly of the split headband
Removal of the latch for headband
1. Use a small flat screwdriver and press out the latch for headband (030).
After the removal the latch can be damaged or get lost. Recommendation: Do not
install this removed latch again. Use new headband latches.
Removal of the the yoke
Before you remove the yoke (020), disassemble the cap, see section 5.1.2.
1. Take out the headband cable from the headband channel of the yoke (020)
2. Remove the yoke from the end piece of headband (010).
Removal of the end piece of headband.
1. Do steps described in the last both sections (latch+yoke removement).
2. Unscrew the 2 screws of the end piece holder.
3. Remove the cover of the end piece holder. For the assembly of the end piece
keep in mind the laying of the cable.
4. Remove the end piece of headband (010) from the end piece holder. During this
step the headband cable in the cable channel of the end piece comes out
automatically.
Check the headband cable for damages. If the headband cable is damaged, remove
the complete headband.
End piece with notch
for cable routing
Cover of the
end piece holder
Screw
Cable channel
of the end piece
Yoke
Cable channel
of the yoke
End piece
End piece
not microphone side
microphone side
Stopper
round
Latch
e.g. 3/64"
Headband cable
Stopper
oval
HMD/HMDC/HME 26 Broadcast
08/2011 13/23