Auto-Search Method - Universal Remote URC-R6 Owner's Manual

Pre-programmed and learning remote control
Table of Contents

Advertisement

If the Three Digit Code did not
work, try this next:

Auto-Search Method

The Auto-Search Method is a way you can scan
through all of the codes in the table to find the right
code for your component.
STEP 1: Manually or using your old remote, turn
on the component you want to program—for
example, to program your TV, turn on your TV set.
STEP 2: On the AVEX R6, press the Component
button that you want to program (in this case the
button that says TV) and the SELECT [SEL] button at
the same time. Hold down both buttons for 2
seconds until the TV Component button light turns
on. This signals that you are in programming
mode.
IMPORTANT: You have 30 seconds to perform
the next step while you are in programming mode.
If you do not press a button within 30 seconds, the
component LED light will turn off. The remote will
exit the programming mode and you will have to
start over.
STEP 3: Point the AVEX R6 remote control toward
the component and press the UP
DOWN
or DOWN arrow button is pressed, the code will
count up (or down) one code number and send a
Power OFF signal. When the correct code is sent
out, the component will turn off.
UP
ARROW
DOWN
arrow) button once. Each time the UP
Page 10
ARROW
arrow (or

Advertisement

Table of Contents
loading

This manual is also suitable for:

Avex r6

Table of Contents