Universal Remote URC-R6 Owner's Manual page 15

IMPORTANT: You have 30 seconds to perform
the next step while you are in programming mode.
If you do not press a button within 30 seconds, the
component LED light will turn off. The remote will
exit the programming mode and you will have to
start over.
STEP 2: Press the component button you want to
turn on and then the POWER button; repeat for all
other components in the order you want them to
turn on. The component LED lights will blink once
each time you press the POWER button.
POWER
COMPONENT
BUTTONS
STEP 3: Once you've entered all the Power On
commands, press the CHANNEL UP button to
save your MacroPower commands. The
component LED lights will blink three times to
confirm that the programming has been
successfully saved.
CHANNEL
UP
SUGGESTION: Most of the components have the
same signal to turn the power On and Off. You
may want to program MacroPower only in the
POWER button and save the System Off button to
turn components On or Off individually.
Note: If you want to program MacroPower for the
SYSTEM OFF button, repeat the same steps used
for Power ON programming.
Page 15