Three-Digit Code Entry Method; Three-Digit Code Set-Up Method - Universal Remote URC-R6 Owner's Manual

I Q S
F UICK

Three-Digit Code Set-Up Method

STEP 1: Find the 3-digit code numbers assigned to
your brand from the lists in the back of this manual.
The codes are listed by component category (i.e.,
TV, VCR, DVD, etc.), then by brand name. For
instance, if you would like to locate a code for a
Sony television, first locate the TV category and
then look for the Sony brand.
STEP 2: Once you have located the 3-digit codes
for each of the components that you wish to
operate with your AVEX R6, write them ALL down
on a piece of paper. It's important that you write
down all the codes listed for your brand because
only one code is going to work with your
component.
STEP 3: Manually or using your old remote, turn
on the component you want to program—for
example, to program your TV turn on your TV set.
STEP 4: On the AVEX R6, press the Component
button that you want to program (in this case the
button that says TV) and the SELECT [SEL] button at
the same time. Hold down both buttons for 2
seconds until the TV Component LED light turns on.
This signals that you are in programming mode.
IMPORTANT: You have 30 seconds to perform
the next step while you are in programming mode.
If you do not press a button within 30 seconds,the
component LED light will turn off. The remote will
exit the programming mode and you will have to
start over.
COMPONENT
BUTTONS
SELECT
BUTTON
-U
ET P DID NOT WORK
Page 8
,
TRY THIS NEXT
: