2. Creating DRUM Section Tones
@ KEY
(Value: C1 to C6)
Po bt Lit
ar:
Designate the keys to be set.
re
td
oan
Note:
The key to be set can also be selected by pressing the desired key directly,
in any of the DRUM Section EDIT screens.
@ WAVE S1 and S2
(Value: 1 through 256)
PR Lt
Cie
Designate the WAVEs for Sources 1 and 2.
Note: The same waveforms available for SINGLE Patches (1 to 256) can be used.
WALE
DR Lh
WA LIE
@ DECAY S1 and S2
(Value: 1 to 100)
Set the DECAY for Sources 1 and 2.
@ TUNE
(Value: —50 to 0 to +50)
DRUM
=]
Adjust the pitch of the Sources. Settings can be made within a range of one octave
THUHE
54
=
| up or down.
@ LEVEL
(Value: 0 to 100)
Adjust the volume levels for the Sources.
@ SUBMIX CH
(Value: A to H)
Within an EFFECT (OUTPUT) Setting, you can set eight types of SUBMIX CHes
which determine the level of the effect and the orientation of the sound image.
Here, the SUBMIX CH to be used as the instrument (DRUM) to be allotted to each
key is selected from among these eight settings. (See P.24, 71)
68
68