Table of Contents
Advertisement
COMPONENT MOUNTING
SIREN MOUNTING: Mount the siren under the hood to fender-well or other body surface with the open end facing
downward. Run the red siren wire through the firewall using a rubber grommet. Ground the black wire to the body
metal near the siren.
LED: Mount the red LED in a visible location on the dashboard or console.
Shock Sensor: Mount the included shock sensor with wire ties to an under dash wire harness or fasten with screws to
firewall or side paneling.
Override/Program Button: Mount the Override/Program push-button in a hidden but accessible location. It is used
for emergency disarm without the use of the transmitter and for programming certain features.
WIRING
PIN 1: GRAY WIRE: INPUT SOURCE FOR REMOTE OUTPUT 1 RELAY
Connect to a +12 Volt source or Chassis Ground depending on the output required for PIN 2 Gray wire See Below.
PIN 2: GRAY WIRE: REMOTE OUTPUT 1 On-Board Relay (Optional)
Connect this wire to an AUX device or function. This output will provide a momentary signal when button #3 is pressed
on the remote control. The (+/-) polarity of this output depends on the connection of PIN 1 Gray wire above.
PIN 3: BLACK WIRE: INPUT SOURCE FOR DOME LIGHT ILLUMINATION RELAY
Connect to a +12 Volt source or Chassis Ground depending on the vehicles dome light circuit. (Required for PIN 4
Black/White wire. See Below.)
PIN 4: BLACK/WHITE WIRE: DOME LIGHT ILLUMINATION OUTPUT On-Board Relay (Optional)
Connect this wire to the vehicle's dome light circuit (May also be connected at the same point as the Door Pin Switch
input). This output will turn on the vehicle's dome light when the system is disarmed using the remote control. The +/-
polarity of this output depends on the connection of the PIN 3 Black wire.
PIN 5: RED WIRE: +12V POWER INPUT (15 Amp Fuse)
Connect to a +12 Volt source with the supplied fuse and fuse-holder. We recommend the connection to be at the
Vehicle's Battery Positive Terminal.
PIN 6: BROWN WIRE: (+) SIREN OUTPUT (3 Amp Max.)
Connect to the siren's RED wire.
PIN 7: VIOLET WIRE: (+) DOOR TRIGGER
Connect to Positive type door switches that show +12 Volts when the door is open and Ground when the doors are
closed. (Many Ford vehicles.)
Advertisement
Table of Contents
