Table of Contents
Advertisement
Standby Mode
Decide what happens when you press the Power button while the ViewBoard is on.
Hibernate
When enabled, pressing the Power button will turn off the ViewBoard and the
system.
Sleep
When enabled, pressing the Power button will turn off the ViewBoard's backlight,
but the system will remain on.
To enable Sleep mode:
1. The user needs to provide their ViewBoard's serial number (S/N) to ViewSonic.
The S/N label is located near the I/O side.
2. ViewSonic will then provide the KEY (FakePowerOff) file to the user.
3. After receiving the KEY file, copy the file to a USB drive.
4. Insert the USB drive into the USB port of the ViewBoard.
NOTE: The KEY file MUST match the ViewBoard's S/N.
5. Select "Sleep".
NOTE:
• The user does not need to restart the system.
• If the user sets the Standby Mode to Hibernate then to Sleep again, the
user needs to repeat steps 3 to 5.
68 68
Advertisement
Table of Contents
