Maintenance - Husqvarna K 540i Operator's Manual

Introduction
WARNING:
safety chapter before you do maintenance
work on the product.
WARNING:
you do maintenance on the product.
WARNING:
correctly can decrease the product life

Maintenance

Clean the external parts of the product.
Make sure that the power trigger and the power trigger lockout function correctly
from a safety point of view.
Do a check of the cutting blade. Look for cracks and make sure that the cutting
blade is not unusually worn. Replace if necessary.
Do a check of the blade guard.
Do a check of the belt guard.
Do a check of the vibration damping system.
Clean the fan housing on the product.
Make sure that the screws and nuts are tight.
Make sure that the control panel works correctly and that it is not damaged.
Do a check of the connections between the battery and the product. Do a check
of the connection between the battery and the battery charger.
Blow through the product and battery soft with compressed air.
Clean the product.
Replace damaged parts.
To clean externally
WARNING:
washer to clean the product.
• Flush the product externally with clean water after
each day of operation. If it is necessary, use a brush.
26
Maintenance
Read and understand the
Remove the battery before
Failure to do maintenance
Do not use a high-pressure
cycle and increase the risk of accidents.
All servicing and/or repair work must also
be done by a professional. Turn to your
servicing dealer for more information.
Maintenance schedule
The following is a list of the maintenance steps that you
must do on the product.
Before
After use Monthly
use
X
X
X
X
X
X
X
X
X
X
X
1960 - 002 - 25.08.2023
X
X