Canon PC300 Service Manual page 94

MECHANICAL SYSTEM
. ELEGTSiCc 5) Detach the bottom cover; see p. 4-3.
vil posee ene 6) Hold the flat cable © with both hands,
SYSTEM
and detach them from the connector by
lifting them straight up.
A. DC Controller/DC Power 7) Disconnect the connector ©.
Supply PCB
1. Detaching the DC Coniroller/DC
Power Supply PCB
1) Detach the body cover; see p. 4-1.
2) Remove the drive release arm @; see
Figure 4-606.
3) 'Remove the screw @, and disconnect
the two connectors @.
4) Disconnect the four fastons @.
Figure 4-702 (front)
8) Disconnect the two connectors @ at the
rear, and detach the grounding wire ©.
Figure 4-701
Figure 4-703
The DC controller/DC power supply
~PCB has high-voltage contacts and
"pick-up sensor lever; take extra care
"not to damage the parts when detach-
ing ihe PCB.
4-16 COPYRIGHT © 1994. CANON INC. CANON PC300/320/225, FC210/290 REV.O JULY 1904 PRINTED IN JAPAN (IMPRIME AU JAPON)