Table of Contents
Advertisement
For iMac and New Power Mac G3 users
There are two ways to initiate VistaScan.
A. Using Application programs to invoke VistaScan
1.
Launch scanning software which supports plug-in drivers (e.g. Presto!
PageManager. If you use other image acquisition software, please refer
to its accompanying documentation for operational details).
2.
Pull down the "File" menu.
3.
Choose "Select Source", and then select the "Plug-ins" command.
4.
Choose "VistaScan" as the data source.
5.
Select the "Acquire" command to activate the scanning interface as
shown below.
6.
The following steps are similar to those in the previous section "For
Windows Users".
For more details about scanning the image, please refer to
the on-line help of V i s t a S c a n
11
Advertisement
Table of Contents
