Panasonic WV-CL700 Operating Instructions Manual page 9

12
13
14
White Set Button
In case the White Balance Selection Switch (11) is
set to LOCK position, the white balance can be set
by pressing this button while aiming the camera at
the white object.
The white balance setting is required whenever the
lighting condition is changed.
Note:
It may not be proper to use the LOCK position in
the following conditions.
o Under coloured illumination
o No white object is available
Power Cord (For WV-CL700)
DC 12V IN Terminal Strip (DC 12V)
(For WV-CL702E)
This terminal accepts DC 12V power source (10.8 -
16V).
15 AC 24V In Terminal Strip (AC 24V)
(For WV-CL704E)
Accepts AC 24V power source (19.5V - 28V).
Be sure to connect grounding lead to the GND
terminal.
Caution:
To Prevent fire or shock hazard, the UL listed wire
VW-1, style 1007 should be used for the cable for
AC 24V input Terminal.
Caution:
To Prevent fire or shock hazard, the UL listed wire
VW-1, style 1007 should be used for the cable for
DC 12V Input Terminal.
16 Flange-back Adjusting Ring
Used to adjust the back focus or picture focus by
rotating this ring to clockwise for C-mount lens or
counterclockwise for special C-mount (CS mount)
lens.
CAUTION:
1. Always set this ring to fully clockwise before
mounting the lens.
2. Do not turn this ring too much to counterclock-
wise when the C-mount lens is mounted as this
could damage the inner glass CCD image sensor.