Panasonic WV-CL700 Operating Instructions Manual page 20

When you use the lens other than listed on page 16, lens 2. Installation of Auto Iris Lens Connector
mount should be C-mount or special C-mount (CS-mount
When you use the Auto Iris Lens other than listed on page
(1"-32UN)) and lens weight should be fess than 420g.
16, install the lens connector (YFE4191J100) coming with
The protrusion of the rear of the lens should be as shown __ the camera as follows.
below.
The following installation should be made by quali-
fied service personnel or system installers.
(1) Cut off the iris control cable at the edge of lens
connector and then cut off the outer cable cover as
shown in the diagram.
Iris control cable Cut off Lens connector
C-mount : Less than 9 mm
CS mount: Less than 4mm
Approximately 8 mm
Iris control cable
ae
-417-