Panasonic WV-CL700 Operating Instructions Manual page 16

C: WV-CL704E
1. A power supply of 24V 50Hz is required.
2. Connect the power cable to the 24V in Terminal
Strip (12) on the rear panel of the camera.
24V AC
(19.5V - 28V)
50 Hz
Copper
wire size
(AWG)
#24 2 #22 2 #20 4
(0.22mm") | (0.33mm*) | (0.52mm*"}
Length
of Cable
(Approx,)
[m]
Caution:
To Prevent fire or shock hazard, the UL listed wire
VW-1, style 1007 should be used for the cable for
AC 24V Input Terminal.
Video Cable
1.
2.
Use a video monitor whose resolution is at least
equal to the camera's.
Terminate the camera output with 75-ohm resistor
at the furthest end of its cable run.
A. Use 75-ohms coaxial cable. (RG-59/U, RG-6/U,
RG-11/U, RG- 15/U) (
B. Always set the last monitor's termination switch
to 75 ohms, and set the termination switches of
intermediate monitors to HIGH (HI-Z).
Monitor Monitor
-13-
C. The maximum extensible coaxial cable length
between the camera and the monitor is shown
in the table 1. Since cable quality varies among
manufacturers, please verify video quality before
final installation, if maximum lengths are to be
used.