Ee Es - Roland GR-700 Owner's Manual

CONNECTIONS
* Before making or breaking connection, be sure to turn all the units off.
Setting up the Guitar Controller
Uniocking
C-24D Connection Cable
1. Guitar Input Connector @
Connect the Guitar Controller here by using the
supplied cable C-24D.
2. Output Jack ®
These jacks are used to connect an amplifier. When
these are the only output jacks used, mixed sound
of direct and synthesizer will be obtained. To fully
benefit the advantages of the GR-700, use keyboard
amplifiers and speakers, PA, or audio equipment. If
two amplifiers are used (stereo), chorus effect will
sound more effective. (See page 13.)
GUITAR INPUT
O Guitar Input Connector
3. Level Selector Switch ®
With this switch, select an appropriate output level
depending on the type of the amplifier you use. The
knack is to select the position that allows undis-
torted sound of desirable level with the amplifier's
volume set to 5 to 7.
4. Guitar Output Jack ®
This jack is provided to connect a guitar amplifier.
Through this jack, only direct guitar sound is sent
out. Also, a preamplifier is built in here, therefore,
good result can be expected when an effect device
or foot volume is used. If both this jack and the
Output Jack @ are used at the same time, only the
synthesizer sound is output through the Output
Jack ®.
Setting up the Amplifiers
Mea a
ls br oureut LEVEL OUTPUT
Se d e e fe
00000 m
i SiR