Roland GR-700 Owner's Manual page 21

Resonance This parameter is used to emphasize the cut-
TAR off point. As you increase the value, the
Š created sound will become more unusual,
more electronic in nature. —
\ly 1 of
~ Y
pS
Ser a
a ~
IN
o 10
ENV Modulation This parameter is used to control the cutoff
ENV Mod point of the VCF in each note with the ENV
curve set in the ENV section. As you increase
i the value, tone color within one note changes "4 y
EN bo more drastically. Y o
>
IN
o 10
Pitch Follow This parameter can shift the cutoff point ER
depending on the pitch. In the "100%" posi- N 4) I
Pltch Follow
tion, it prevents any
inconsistency in the
l Y) l
. . ` m 'a
harmonic contents caused by pitch alteration. " "
= — 100% o — a
a.
© Parameter value 92 > 100%
co cy
LFO Modulation This parameter is used to control the cutoff
LFO Mod point by the waveform of the LFO section.
5 Rotating the knob clockwise deepens the -jl j
| modulation. ~~ om,
\17 171
S Y aa
de way
o 10
HPE STERN | The HPF (High Pass Filter) is a filter that
HPF passes higher frequency harmonics and cuts
5 off the lower ones. As you increase the value, y o
QA l A cutoff point goes up, lower frequency har- are ~
=e Fa monics being cut off. +. e.
Polarity Switch
This is to select the polarity of the Envelope
II
curve. Usually / may be used. In \ 7 mode, |
ADSR pattern will be inverted, so as the tone
PEN
H }
fn
color alteration
is. The depth of the ENV -l
==
T
curve is adjusted with the ENV Modulation
| FL! y
Knob. Da
t
Ll
21