Peavey Spectrum Bass II Operation Manual page 4

Chapter 1 Introduction
QUICK START
Hey, we know not everyone likes to read manuals or even needs to read manuals, that's why we are providing this
quick: start section. We want to make using your new Peavey equipment an easy, enjoyable experience.
▼ To get started quickly
1. The first thing you need to do is to connect the Spectrum Bass II to your system configuration. Here are some
things to check first:
Make sure your amplification system is turned off.
Turn the Spectrum Bass ITs Volume knob fully counterclockwise.
^ Plug the MIDI Out from your keyboard to the MIDI In on the Spectrum Bass H
Connect the mono/right audio output of the Spectrum Bass II to the input of your keyboard amplifier. (If
possible use a stereo connection; you won't be disappointed. Connect the left and right audio outputs to
your amplification system with mono cables or use a stereo cable connected to the stereo/left audio output.)
Connect the power jack of the Spectrum Bass n to an electrical outlet using the 16-16.5 volt AC 1000 mA
adapter provided.
Turn on your amplifier.
See the diagram below.
DPM* 4
KB" 300
2
Spectrum' Bass II