Chapter 2 Overview; The Front Panel.<5; The Back Panel.5 - Peavey Spectrum Bass II Operation Manual

Chapter 2 Overview
Chapter 2 Overview
16VACA/
1 AMP
o •
^^ARNIN<^^
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING:
to reduce the
RISK OF FIRE OR ELECTRIC SHOCK
DO NOT EXPOSE THIS EQUIPMENT!
TO RAIN OR MOISTURE.
AVIS:
RISQUE DE CHOC ELEC
TRlQUE-NE PAS OUVRIR.
MIDI
m
to to ito
OUT THRU
THE FRONT PANEL
1. Volume Knob
The Volume knob adjusts the overall volume of the Spectrum Bass H
2. LED Display
This is a three-digit, seven-segment display.
3. Up and Down Arrow Buttons (▼ and
A)
These buttons are used to inc/dec through programs and to edit parameters.
4. Channel Button
The Channel button is used to select the MIDI receive channel. Channels 1-16 are available.
5. Transpose Button
The Transpose button is used to adjust the pitch. The Spectrum Bass II may be transposed any number of
semitones to ±2 octaves.
6. Fine Button
The Fine button is used to perform fine tune adjustments to the pitch. The range is ±99 cents.
7. Mode Select Button/LEDs
The Mode Select button is used to select the MIDI mode. There are six choices available: Omni, Poly, Multi,
Legato, Poly-Legato, and Multi-Legato. It is also used to edit the number of MIDI channels the unit will respond
to in multi-timbral mode.
THE BACK PANEL
1. Power Jack
Use only the 16-16.5 volt AC 1000 mA adaptor provided. (Peavey Part #00710160)
Caution
: Use only the Peavey 16-16.5 volt power supply provided with this product. If the original power
supply must be replaced, consult your Peavey dealer or the factory for die correct replacement. Failure to use
6
Spectrum
"
Bass II