U-Line Echelon CO2175FF Installation Manual page 9

15/32"
ø 0.177" (#16 Drill)
11/16" Deep
.125"
1/4" Ref
3/4" Min Ref
SIDE VIEW
13/32"
Figure 16
Route notch in top corner of overlay panel as shown
(see Top and Side Views). Top of notch is entire depth
of panel, front to back.
Width: 31/32"
Depth: 1/8"
CAUTION
Be careful not to drill too deep! Drilling holes too deep
may destroy your door panel.
3. Drill hole for upper door hinge (top of panel) (see
Figure 16, Top View).
0.177" diameter
(#16 drill) x 11/16" deep
4. Drill hole for lower door hinge (see Figure 16, Bottom
View).
5/16" diameter x 1/4" deep
CAUTION
It is important to ensure that all drilled holes are drilled to
the correct depth in order to avoid splits in the wood
when hardware is installed.
08/2006
CO2175FF — Combo® Ice Maker/Refrigerator
TOP VIEW
3/8"
31/32"
11/16"
Ref
BACK VIEW
3/8"
BOTTOM VIEW
ø 5/16" x 1/4" Deep
Chamfer 1/32" x 45°
ULIN_0401_A
Installation Instructions
Removing Existing Door
1. Remove the door shelves by first pulling shelves up at
a 45° angle, then straight out.
2. Remove top hinge screw pin (Phillips screwdriver).
Remove the door by tilting forward and lifting off the
bottom hinge pin.
3. Pull door gasket out of the groove (top edge of door only).
Start in the middle and pull outward, moving toward the
edge (see Figure 17). This may take some force.
Figure 17
4. Remove the two screws located on both sides of the
handle.
5. Remove the handle and discard. (This handle will be
replaced with the Overlay Handle included in the Full
Overlay Door Panel Kit.)
6. Slide the existing door panel out of the doorframe.
Attaching the Full Overlay Panel
1. Place and tape the existing door panel on the back of the
overlay panel (see Figure 19) and drill holes through
both panels according to Figure 20. Remove tape
adjoining the panels and enlarge the six holes in the steel
(black/white vinyl color) panel using a 0.201" (#7) drill.
2. If a user-supplied cabinet handle will be used, attach its
hardware to the overlay panel at this time.
Tape
Back of
Wood
Panel
1-3/4" Top
Top of
Wood Panel
Figure 19
9
Old Handle
New Handle
Figure 18 ULIN_0403_A
Removed
Door Panel
Side of
Wood Panel
3/8"
Both Sides
www.U-LineService.com