Product Dimensions; Door Swing/Clearances Information; Reversing The Door - U-Line Echelon CO2175FF Installation Manual

Product Dimensions

23-11/16"
Including
Handle
34-1/8"
23-15/16"
Black and White
Figure 2
Please note that the unit has adjustable feet that can add
one additional inch to height during leveling or to match
adjacent cabinets (see Figure 37 on Page 14).

Door Swing/Clearances Information

Black and White units have a zero clearance for the door
to open 90° (see Figure 3). Stainless Steel models require
a minimum of 2-1/8" door clearance to accommodate the
handle if the unit is installed next to a wall or similar type
of structure.
Wall
1/4" Min.
21-7/16"
25-1/2"
90°
Door Swing
Black and White
Figure 3
08/2006
CO2175FF — Combo® Ice Maker/Refrigerator
25-13/16"
Including
Handle
34-1/8"
23-15/16"
Stainless Steel
Wall
2-1/8" Min.
21-7/16"
25-1/2"
90°
Door Swing
Stainless Steel

Reversing the Door

(Black and White Units Only)
All U-Line units
(except Stainless
Steel models) may be
left- or right-hand
opening. The door
opening is easily
reversed by moving
the hinge hardware
to the opposite side.
The top hinge
hardware will be
used on the bottom
of the other side and
the bottom hinge
hardware will be
used on the top of
the other side (see
Figure 4).
To reverse the door:
1. Remove top hinge
screw pin from
door (Phillips screwdriver) (see Figure 5). Remove door
by tilting forward and lifting off bottom hinge pin.
2. Remove plastic screw plugs (3 each, top and bottom)
from new hinge location. Do not discard (see Figure 6).
Figure 5
ULIN_0133_A
3. Remove top hinge (3 screws), reinstall hinge screw pin,
and remount on opposite side BOTTOM (see Figure 7).
5
Figure 4
ULIN_0015_A
Screw Plugs
Figure 6
www.U-LineService.com