Leveling Information; Installation Tip - U-Line Echelon CLRCO2175 Combo Installation Manual

8 Level the Unit

Leveling Information

IMPORTANT
It is extremely important that the unit is level. If it is not
level, the ice mold will not fill evenly.
A unit that is not level can
cause a reduction in ice rate,
uneven sized cubes or water
spilling into the storage
area, which will cause the ice
in the bin to melt
prematurely (see Figure 42).
Remember that floors near
drains have a tendency to
slope towards the drain.
1. Use a level to check the
levelness of the ice maker
from front to back and
from side to side. Level
should be placed along
top edge and side edge
as shown (see Figure 43).
08/2006
CLRCO2175 Combo®— Clear Ice Maker/Refrigerator
Figure 42
1
ULIN_0193_A
Figure 43
2. If the ice maker is not level, adjust the feet on the
corners of the unit as necessary (see Figure 44).
Figure 44
3. Check the levelness after each adjustment and repeat
the previous steps until the unit is level. Go on to
9 Install the Unit.

Installation Tip

If the room floor is higher than the floor in the cut-out
opening, adjust the rear feet to achieve a total unit rear
height of 1/8" less than the opening's rear height. Shorten
the unit height in the front by adjusting the front feet.
This allows the unit to be gently tipped into the opening.
Readjust the front feet to level the unit after it is correctly
positioned in the opening.
17
Turn Foot to Adjust
www.U-LineService.com