Digital Signal Processor (Dsp) Operation - Pioneer DEH-P825R Operation Manual

Digital Signal Processor (DSP) Operation
4. Press the (+) or (A) button or the (-) or (¥)
button to raise or lower the frequency level.
5. Press the DSP button for 2 seconds or longer
again to exit the 13-Band G.EQ Adjustment
mode.
¢ Store the adjusted equalizer curve in the
User mode (refer to following section) to
prevent resetting when another curve is
selected.
Ls
Storing equalizer curves (User mode)
Folfowing equalizer curve adjustment, the new
curve can be stored under one of the four user
buttons.
=]
-
See the "Equalizer curve adjustment".
. Adjust the Equalizer curve. ssf
2. Press your choice of buttons 1-4 for 2
seconds or longer.
An appropriate message is displayed depending
on the button ("MEM-USR1" for the User |
button, etc.), indicating that the curve is stored
for later recall with the button in question.
To exit the Digital Equalizer mode
* Use the DSP button to exit the Digital
Equalizer mode.
02