Husqvarna DM1 PACE Operator's Manual page 21

Troubleshooting of the control panel
The LED indicators on the control panel show the state
of charge of the battery and if there are problems with
the product.
LED Indication
indica-
tor
Indicator no. 1
1 and is on and indi-
3 cator no. 3
flashes.
All 4 indicators
2
flash.
The indicator is
3
on.
Indicator no. 3
2 and and the first
3 LED on indica-
tor no. 2 flash.
Load indicator.
Load indicators
CAUTION:
can do damage to the product.
1941 - 005 - 25.09.2023
Cause
Temperature deviation.
The product does a Firmware
Over-the-Air (FOTA) update.
Servicing is necessary
The start switch is in Start position
when you start the product.
The battery is damaged.
Servicing is necessary.
The battery level is low.
Load indicators on page 21 .
Refer to
Overload again and again
Solution
The product is too hot or too cold.
Let the FOTA update finish.
Speak to an approved Husqvarna service center.
Set the start switch to the Off position before you
start the product.
Do a test with a different battery.
Speak to an approved Husqvarna service center.
Charge the battery.
1
2
3
21