Husqvarna DM1 PACE Operator's Manual page 17

2. Push the re-bar button (A) one time. The speed is
decreased and the LED indicator on the button is on
while the function is on.
A
3. Drill through the iron.
4. Push the re-bar button (A) again. The speed is
increased back to usual speed.
To stop the product
WARNING:
rotate for some time after the motor stops.
Do not stop the drill bit with your hands.
Injuries can occur.
1. Push the start/stop button to stop the drill bit.
2. Wait until the drill bit stops fully.
3. Push the On/Off button until the green LED light
goes off.
1941 - 005 - 25.09.2023
The drill bit continues to
4. Push the battery release button (A) and remove the
battery from the battery holder to prevent accidental
start.
A
To reset the motor overload protection
1. Stop the product. Refer to
page 17 .
2. Remove the blockage from the drill bit and make
sure that the drill bit can move freely.
3. Start the product. Refer to
5 .
To replace the drill bit
WARNING:
before you replace the drill bit on the
product.
WARNING:
the product become cool before you remove
the drill bit. The drill bit and the adjacent
area can be very hot after operation.
WARNING:
that are approved for your product. Speak to
your Husqvarna dealer for more information.
1. Make sure that you have got a new drill bit, 2
wrenches and water resistant grease.
To stop the product on
Safety definitions on page
Always remove the battery
Use protective gloves. Let
Only use diamond drill bits
17