Husqvarna DM1 PACE Operator's Manual page 13

3. Look for the dimension of the core drill on the top of
the drill.
4. Cut a hole in the sealing disc in the nearest smaller
dimension as the core drill.
5. Connect the slurry collector to the connection of the
slurry ring.
1941 - 005 - 25.09.2023
6. Put the slurry ring on the drill spindle (C). Install the
drill bit to the drill spindle (D).
C
7. Start the slurry collector.
8. Lift the drill bit to the ceiling. Attach the slurry ring to
the ceiling.
To connect and open the water supply
CAUTION:
maximum water pressure is not too high.
Technical data on page 23 .
Refer to
CAUTION:
prevent that dirt causes a blockage in the
water system.
CAUTION:
supply coupling. Speak to your dealer for
more information.
D
Make sure that the
Use only clean water to
Use only an approved water
13