HP 4262A Operating And Service Manual page 28

Section III
Figure 3-2
Model 4262A
"rrr-r^;"
BCD D/Q DATA OUTPUT Connector:
BCD parallel data of measured dissipation
factor (D) or quality factor (Q) are output¬
ted through this 50 pin connector installed
on the 4262A Option 001.
BCD LCR DATA OUTPUT Connector:
With Option 001, BCD parallel data for in-
ductance, capacitance and resistance meas¬
ured values are outputted through this 50
pin connector.
COMPARATOR OUTPUT Connector: The
4262A Option 004 provides comparator
decision outputs for LCR and D/Q through
this 50 pin connector.
HP-IB Digital Bus Connector: This 24 pin
connector conveys bus signals and remote
programming instructions to the 4262A
Option 101 and transmits data from the
4262A Option 101 to the bus.
Address Switch: This seven section switch
sets address code of 4262A Option 101 and
TALK ONLY or ADDRESSABLE mode of
operation.
EXT DC BIAS Connector; External dc
bias voltage can be applied to the sample
up to the maximum voltage of plus 40V
through this connector.
EXT TRIGGER Connector: This connector
is used for externally triggering the instru¬
ment by inputting an external trigger signal.
TRIGGER SWITCH on front panel should
be set to EXT.