D-Link DWR-956 User Manual page 248

DWR-956 Wireless AC1200 4G LTE Router
with Gigabit Ethernet Ports and 1 FXS Port
User Manual
Parameter
Set as
Start IPv4 address /
Start IPv6 address
End IPv4 address /
End IPv6 address
Subnet IPv4 address /
Subnet IPv6 address
Select the destination of the packet direction from the Destination
drop-down list.
Router: The rule will be applied to the packets transmitted
•
to DWR-956.
WAN: The rule will be applied to the packets transmitted to
•
the external network.
LAN: The rule will be applied to the packets transmitted to
•
the local network.
GRE: The rule will be applied to the packets transmitted to
•
the GRE tunnel (available if a GRE tunnel has been created
on the device).
IPsec: The rule will be applied to the packets transmitted to
•
the IPsec tunnel (available if an IPsec tunnel has been
created on the device).
PPTP Server: The rule will be applied to the packets
•
transmitted to the PPTP server (available if a PPTP server
has been created on the device).
L2TP Server: The rule will be applied to the packets
•
transmitted to the L2TP server (available if an L2TP server
has been created on the device).
From the Source interface and Destination interface drop-
down lists, select source and destination interfaces for which the rule
will be applied. Leave the Auto values to apply the rule to all
created WAN interfaces.
Source IP address
Select the needed value from the drop-down list.
The source host start IPv4 or IPv6 address.
If it is necessary to specify a single address, leave the End IPv4
address / End IPv6 address field blank.
You can choose a device connected to the router's LAN at the
moment. To do this, select the relevant IPv4 or IPv6 address from
the drop-down list (the field will be filled in automatically).
The source host end IPv4 or IPv6 address.
The source subnet IPv4 or IPv6 address. The field is displayed when
the Subnet value is selected from the Set as drop-down list.
Page 248 of 302
Configuring via Web-based Interface
Description