Table of Contents
Advertisement
OPERATING YOUR WAShER
1. Ready mode
1) Coin / Card type
– The cycle LEDs are lit at the same time,
when the price of cycles are equal.
2) OPL type
– The cycle LEDs flash at the same time,
and displayed 'PUSH'.
2. Insert card/coin (not for OPL type)
Insert a cash card that has a sufficient balance.
The card balance should be more than the
programmed vend price for a selected cycle.
NOTE
• When the card balance is not enough,
machine displays the card balance for 5
seconds and then displays
message repetitively
• Insert a sufficient amount of change that
is more than the programmed vend price
for the selected cycle.
NOTE
• The machine will not start until sufficient
coins are inserted.
3. Select the cycle
Press the desired button and press the
start button.
The display LED will show the remaining
time and the selected cycle starts.
• Select cycles designed for different types of
fabric and soil levels.
Wash/Rinse
CYCLE
90°C (194°F)
Extra Hot/Cold
75°C (167°F)
Extra Hot/Cold
60°C (140°F)
Hot/Cold
40°C (104°F)
Warm/Cold
Cold
Cold/Cold
Spin Speed
Temp.
High
High
High
Middle
Low
OPERATING YOUR WASHER
4. Custom PGM
Press and hold 'Cold' button for 3 seconds.
You can use courses you have created.
(Only OPL Type)
5. Change course
You cannot change the course while the
machine is running.
6 . Cycle finish
The machine stops and LED display shows
"
" with beeper sound.
❋ Do not work any button and stop the washer
(When the washer is operating) or (when a
cycle is in progress)
WARNING
• To reduce the risk of fire, electric shock, or
injury to persons, read the IMPORTANT
SAFETY INSTRUCTIONS before operating
this appliance.
21
Advertisement
Table of Contents
